In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.Ģ004/108/EC (EMC directive): Hereby, UTC Fire & Security declares that this device is in compliance or with the essential requirements and other relevant provisions of Directive 2004/108/EC.Ģ002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. This Class A digital apparatus complies with Canadian ICES-003.Ĭet appareil mumérique de la classe A est conforme à la norme NMB-003 du Canada. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. KelvinstrDH Weert, The NetherlandsĬlass A: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. United Technologies Corporation 2955 Red Hill Avenue, Costa Mesa, CA 92626-5923, USAĪuthorized EU manufacturing representative: UTC Fire & Security B.V. Trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. Interlogix is part of UTC Buildings & Industrial Systems, a unit of United Technologies Corporation. Recording starts automatically.© 2014 United Technologies Corporation. When all the required changes have been entered, click The wizard will then guide you through the menus to set the time and date, network configuration, HDD management, and recording configuration. It is strongly recommended that this password is changed. Select the preferred language for the system and then enter the administrator password. The wizard walks you through some of the more important settings of your NVR. By default, the setup wizard will start once the NVR has loaded. The configuration can then be customized as required. It configures all cameras simultaneously. The NVR has an express installation wizard that lets you easily configure basic NVR settings when first used. Connect the mouse to the USB port in the front panel.Īll the other connections shown are optional and depend upon installation requirements.Ģ. See Figure 1 on page 1.Ĭonnect monitor A to the VGA or HDMI output. Connect all the devices required to theīack panel of the NVR. Recommended steps for setting up the NVR:ġ. Įnsure that the unit is in a well- ventilated area.ĭo not expose the unit to rain or moisture.Refer to the user manual for detailed information, but observe these important requirements: The TruVision NVR 10 (model TVN 10) is shipped with the following items: Alarm: A steady RED light indicates that there is a sensor Alarm In. ![]() A steady RED light indicates internal health failure. Internal: A steady GREEN light indicates that the NVR is currently recording video/audio. ![]() No light indicates that the NVR is not connected to any network. ![]() Network: A steady GREEN light indicates that the NVR is currently connected to a network. A steady RED light indicates HDD failure. HDD: A steady GREEN light indicates that the NVR is accessing the HDD in read or write operation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |